Allied Telesis IE340 Series - show ip resolve-via-default

C613-50631-01 Rev A Command Reference for IE340 Series 1009
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ROUTING COMMANDS
SHOW
IP RESOLVE-VIA-DEFAULT
show ip resolve-via-default
Overview Use this command to see whether it is possible to use a default route to resolve
next hops in IP routing. By default it is possible, but this can be changed with the
no variant of the command ip resolve-via-default.
Syntax
show ip resolve-via-default
Mode User Exec
Example To show whether default routes are used to resolve next hops or not, use the
command:
awplus# show ip resolve-via-default
Output Figure 25-1: Example output from show ip resolve-via-default:
Related
commands
ip resolve-via-default
Command
changes
Version 5.5.3-0.1: command added
awplus#show ip resolve-via-default
IP resolve via default is off