C613-50631-01 Rev A Command Reference for IE340 Series 300
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
INTERFACE MEMORY
show interface memory
Overview This command displays the shared memory used by either all interfaces, or the
specified interface or interfaces. The output is useful for diagnostic purposes by
Allied Telesis authorized service personnel.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show interface memory
show interface <port-list> memory
Mode User Exec and Privileged Exec
Example To display the shared memory used by all interfaces, use the command:
awplus# show interface memory
To display the shared memory used by port1.0.1 and port1.0.3 to port1.0.4, use the
command:
awplus# show interface port1.0.1,port1.0.3-port1.0.4 memory
Output Figure 7-8: Example output from the show interface memory command
Parameter Description
<port-list> Display information about only the specified port or ports. The port
list can be:
• a switchport (e.g. port1.0.4)
• a static channel group (e.g. sa2)
• a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen (e.g.
port1.0.1-1.0.4)
• a comma-separated list (e.g. port1.0.1,port1.0.3-1.0.4). Do not mix
port types in the same list.
awplus#show interface memory
Vlan blocking state shared memory usage
---------------------------------------------
Interface shmid Bytes Used nattch Status
port1.0.1 491535 512 1
port1.0.2 393228 512 1
port1.0.3 557073 512 1
...
lo 425997 512 1
po1 1179684 512 1
po2 1212453 512 1
sa3 1245222 512 1
To Next Page
Loading...
