C613-50631-01 Rev A Command Reference for IE340 Series 1258
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPFV3 FOR IPV6 COMMANDS
IPV
6 OSPF PRIORITY
ipv6 ospf priority
Overview This command sets the router priority, which is a parameter used in the election of
the designated router for the link.
The no variant of this command returns the router priority to the default of 1.
Syntax
ipv6 ospf priority <priority>
no ipv6 ospf priority
Default The default priority is 1.
Mode Interface Configuration for a VLAN interface.
Usage Set the priority to help determine the OSPF Designated Router (DR) for a link. If two
routers attempt to become the DR, the router with the higher router priority
becomes the DR. If the router priority is the same for two routers, the router with
the higher router ID takes precedence.
Routers with zero router priority values cannot become the designated or backup
designated router.
Example The following example shows setting the OSPFv3 priority value to 3 on the VLAN
interface vlan2:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 ospf priority 3
Parameter Description
<priority> <0-255>
Specifies the router priority of the interface. The larger the value,
the greater the priority level. The value 0 defines that the device
cannot become either the DR, or backup DR for the link.
To Next Page
Loading...
Need help?
General
