Allied Telesis IE340 Series - test

C613-50631-01 Rev A Command Reference for IE340 Series 3380
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
TRIGGER COMMANDS
TEST
test
Overview This command puts the trigger into a diagnostic mode. In this mode the trigger
may activate but when it does it will not run any of the trigger’s scripts. A log
message will be generated to indicate when the trigger has been activated.
The no variant of this command takes the trigger out of diagnostic mode, restoring
normal operation. When the trigger activates, the scripts associated with the
trigger will be run, as normal.
Syntax
test
no test
Mode Trigger Configuration
Usage notes Configure a trigger first before you use this command to diagnose it. For
information about configuring a trigger, see the Triggers_Feature Overview and
Configuration Guide.
Examples To put trigger 5 into diagnostic mode, where no scripts will be run when the trigger
activates, use the commands:
awplus# configure terminal
awplus(config)# trigger 5
awplus(config-trigger)# test
To take trigger 205 out of diagnostic mode, restoring normal operation, use the
commands:
awplus# configure terminal
awplus(config)# trigger 205
awplus(config-trigger)# no test
Related
commands
show trigger
trigger