Allied Telesis IE340 Series - spanning-tree transmit-holdcount

C613-50631-01 Rev A Command Reference for IE340 Series 767
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SPANNING TREE COMMANDS
SPANNING
-TREE TRANSMIT-HOLDCOUNT
spanning-tree transmit-holdcount
Overview Use this command to set the maximum number of BPDU transmissions that are
held back.
Use the no variant of this command to restore the default transmit hold-count
value.
Syntax
spanning-tree transmit-holdcount
no spanning-tree transmit-holdcount
Default Transmit hold-count default is 3.
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# spanning-tree transmit-holdcount