C613-50631-01 Rev A Command Reference for IE340 Series 3081
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
PROBE
TYPE
probe type
Overview Use this command to set the probe type for a DHCP pool. The probe type specifies
how the DHCP server checks whether an IP address is being used by other hosts,
referred to as lease probing. If arp is specified, the server sends an ARP request to
determine if an address is in use. If ping is specified, the server will send an ICMP
Echo Request (ping).
The no variant of this command sets the probe type to the default setting, ping.
Syntax
probe type {arp|ping}
no probe type
Default The default probe type is ping.
Mode DHCP Pool Configuration
Examples To set the probe type to arp for the pool P2, use the commands:
awplus# configure terminal
awplus(config)# ip dhcp pool P2
awplus(dhcp-config)# probe type arp
To set the probe type for the pool P2 to the default, ping, use the commands:
awplus# configure terminal
awplus(config)# ip dhcp pool P2
awplus(dhcp-config)# no probe type
Related
commands
ip dhcp pool
probe enable
probe packets
probe timeout
show ip dhcp pool
Parameter Description
arp Probe using ARP.
ping Probe using ping.
To Next Page
Loading...
Need help?
General
