C613-50631-01 Rev A Command Reference for IE340 Series 776
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
UDLD
ENABLE
udld enable
Overview Use this command to enable UDLD on all of a device’s fiber-optic ports. It has no
effect on copper ports. Use the udld port command to enable UDLD on copper
ports.
Use the no variant of this command to disable the UDLD feature on all of a device’s
fiber interfaces.
Syntax
udld enable
no udld enable
Default UDLD is disabled by default.
Mode Global Configuration
Example To enable the UDLD feature on all fiber interfaces, use the command:
awplus# configure terminal
awplus(config)# udld enable
Related
commands
show udld
show udld neighbors
udld aggressive-mode
udld port
udld port disable
udld reset
udld time disable-period
udld time message-interval
To Next Page
Loading...
Need help?
General
