C613-50631-01 Rev A Command Reference for IE340 Series 1307
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
ADDRESS
-FAMILY
address-family
Overview This command enters the IPv4 or IPv6 Address-Family Configuration command
mode. In this mode you can configure address-family specific parameters.
Syntax [BGP]
address-family ipv4 [unicast]
no address-family ipv4 [unicast]
Syntax [BGP4+] address-family ipv6 [unicast]
no address-family ipv6 [unicast]
Mode [BGP] Router Configuration
Mode [BGP4+] Router Configuration
Usage notes To leave the IPv4 or IPv6 Address Family Configuration mode, and return to the
Router Configuration mode, use the exit-address-family command.
Example [BGP]
awplus# configure terminal
awplus(config)# router bgp 100
awplus(config-router)# neighbor 192.168.0.1 remote-as 100
awplus(config-router)# address-family ipv4
awplus(config-router-af)# neighbor 192.168.0.1 activate
awplus(config-router-af)# exit-address-family
awplus(config-router)#
Example [BGP4+] awplus# configure terminal
awplus(config)# router bgp 100
awplus(config-router)# neighbor 2001:0db8:010d::1 remote-as 100
awplus(config-router)# address-family ipv6
awplus(config-router-af)# neighbor 2001:0db8:010d::1 activate
awplus(config-router-af)# exit-address-family
awplus(config-router)#
Related
commands
exit-address-family
Parameter Description
ipv4 Configure parameters relating to the exchange of IPv4 prefixes.
ipv6 Configure parameters relating to the exchange of IPv6 prefixes.
unicast Configure parameters relating to the exchange of routes to unicast
destinations.
To Next Page
Loading...
Need help?
General
