C613-50631-01 Rev A Command Reference for IE340 Series 3135
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DHCP FOR IPV6 (DHCPV6) COMMANDS
SHOW
IPV6 DHCP INTERFACE
show ipv6 dhcp interface
Overview Use this command in User Exec or Privileged Exec mode to display DHCPv6
information for a specified interface, or all interfaces when entered without the
interface parameter.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 dhcp interface [<interface-name>]
Mode User Exec and Privileged Exec
Example To display DHCPv6 information for all interfaces DHCPv6 is configured on, use the
command:
awplus# show ipv6 dhcp interface
Output Figure 59-5: Example output from the show ipv6 dhcp interface command
Parameter Description
<interface-name> Optional. Specify the name of the interface to show DHCPv6
information about. Omit this optional parameter to display
DHCPv6 information for all interfaces DHCPv6 is configured on.
awplus# show ipv6 dhcp interfaceď€
vlan1 is in client modeď€
Address 1001::3c0:1ď€
preferred lifetime 9000, valid lifetime 5000ď€
starts at 20 Jan 2021 09:21:35ď€
expires at 20 Jan 2021 10:25:32
Table 2: Parameters in the output of the show counter dhcp-client command
Parameter Description
<interface> is in
client mode
Displays that the specified interface is in client
mode.
Address Displays the address of the DHCPv6 server on the
interface.
Preference Displays the preference value for the DHCPv6
server.
To Next Page
Loading...
Need help?
General
