C613-50631-01 Rev A Command Reference for IE340 Series 777
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
UDLD
PORT
udld port
Overview Use this command to enable UDLD on an interface.This command enables UDLD
on both copper and fiber ports.
Use the no variant of this command to disable UDLD on an interface.
Syntax
udld port
no udld port
Default UDLD is disabled on an interface by default.
Mode Interface Configuration
Usage notes • This command always enables the UDLD feature on a port.
•The udld port disable command overwrites this command and disables
UDLD on an interface.
• If UDLD has been set globally, using the udld enable command, then
AlliedWare Plus ignores the no udld port command on a fiber interface.
Example To enable UDLD on port1.0.1, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# udld port
To disable UDLD on port1.0.1, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no udld port
Related
commands
show udld port
show udld neighbors
udld enable
udld port disable
udld reset
udld time disable-period
udld time message-interval
To Next Page
Loading...
Need help?
General
