C613-50631-01 Rev A Command Reference for IE340 Series 3117
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DHCP FOR IPV6 (DHCPV6) COMMANDS
IP
DHCP-RELAY AGENT-OPTION REMOTE-ID
ip dhcp-relay agent-option remote-id
Overview Use this command to specify the Remote ID sub-option of the DHCP Relay Agent
Option 82 field the DHCP Relay Agent inserts into clients’ request packets. The
Remote ID identifies the device that is inserting the DHCP Relay Agent Option 82
information. If a Remote ID is not specified, the Remote ID sub-option is set to the
device’s MAC address.
Use the no variant of this command to return the Remote ID for an interface.
For DHCP Relay Agent and DHCP Relay Agent Option 82 introductory information,
see the DHCP Feature Overview and Configuration Guide.
Syntax
ip dhcp-relay agent-option remote-id <remote-id>
no ip dhcp-relay agent-option remote-id
Default The Remote ID is set to the device’s MAC address by default.
Mode Interface Configuration for VLAN interfaces.
Usage notes The Remote ID sub-option is included in the DHCP Relay Agent Option 82 field of
relayed client DHCP packets if:
• DHCP Relay Agent Option 82 is enabled (ip dhcp-relay agent-option), and
• DHCP Relay Agent is enabled on the device (service dhcp-relay)
Examples To set the Remote ID to myid for client DHCP packets received on vlan2, use the
commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip dhcp-relay agent-option remote-id myid
To remove the Remote ID specified for vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ip dhcp-relay agent-option remote-id
Related
commands
ip dhcp-relay agent-option
ip dhcp-relay agent-option checking
show ip dhcp-relay
Parameter Description
<remote-id> An alphanumeric (ASCII) string, 1 to 63 characters in length.
Additional characters allowed are hyphen (-), underscore (_)
and hash (#). Spaces are not allowed.
To Next Page
Loading...
Need help?
General
