C613-50631-01 Rev A Command Reference for IE340 Series 2640
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
VRRP COMMANDS
ENABLE
(VRRP)
enable (VRRP)
Overview Use this command to enable the VRRP session on the router to make it participate
in virtual routing. To make changes to the VRRP configuration, first disable the
router from participating in virtual routing using the disable (VRRP) command.
Syntax
enable
Mode Router Configuration
Usage notes You must configure the virtual IP address and define the interface for the VRRP
session (using the virtual-ip or virtual-ipv6 and the router vrrp (interface) or router
ipv6 vrrp (interface) commands) before using this command.
See the VRRP Feature Overview and Configuration Guide for more information
about VRRPv3 IPv4 and IPv6 configuration details.
Examples To enable the VRRP session for VRRP VR ID 5 on vlan2, use the commands:
awplus# configure terminal
awplus(config)# router vrrp 5 vlan2
awplus(config-router)# enable
To enable the VRRPv3 session for VRRPv3 VR ID 3 on vlan1, use the commands:
awplus# configure terminal
awplus(config)# router ipv6 vrrp 3 vlan1
awplus(config-router)# enable
Related
commands
disable (VRRP)
router vrrp (interface)
router ipv6 vrrp (interface)
show vrrp
virtual-ip
virtual-ipv6
Command
changes
Version 5.5.2-2.1: command added on 10GbE UTM Firewall and AR4000S-Cloud
To Next Page
Loading...
Need help?
General
