C613-50631-01 Rev A Command Reference for IE340 Series 3466
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MODBUS COMMANDS
SCADA
MODBUS TCP SERVER ACCESS
scada modbus tcp server access
Overview Use this command to configure the type of requests that are allowed to be made
to the MODBUS TCP server.
Use the no variant of this command to revert to the default of read-only.
Syntax
scada modbus tcp server access {read-only|read-write}
no scada modbus tcp server access
Default Read-only.
Mode Global Configuration
Example To allow read and write requests to the MODBUS TCP server, use the following
commands:
awplus# configure terminal
awplus(config)# scada modbus tcp server access read-write
To change from read-write access back to the default of read-only, use the
following commands:
awplus# configure terminal
awplus(config)# no scada modbus tcp server access
Related
commands
scada modbus tcp server port
scada modbus tcp server connection
show scada modbus tcp server
clear scada modbus tcp server connection
clear scada modbus tcp server statistics
show scada modbus tcp server connections
Command
changes
Version 5.4.8-2.1: command added
Version 5.4.9-0.1: MODBUS support added for x930, x950 series
Version 5.5.0-1.1: MODBUS support added for IE510 series
To Next Page
Loading...
Need help?
General
