C613-50631-01 Rev A Command Reference for IE340 Series 1826
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
SERVICE
PIM
service pim
Overview Use this command to enable PIM sparse mode services.
Use the no version of the command to disable unused PIM sparse mode services.
Syntax
service pim
no service pim
Default Enabled
Mode Global Configuration
Usage notes Sometimes it may be desirable to disable unused services, in order to reduce
memory use.
Disabling the PIM services will only take effect after you save the configuration and
restart the device.
Example To disable the PIM sparse mode service, use the commands:
awplus# configure terminal
awplus(config)# no service pim
Output Figure 35-3: Example output from no service pim
Command
changes
Version 5.5.0-0.1: command added
awplus(config)#no service pimď€
% Save the config and restart the device for this change to take
effect
To Next Page
Loading...
Need help?
General
