C613-50631-01 Rev A Command Reference for IE340 Series 959
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV6 COMMANDS
IPV
6 ADDRESS SUFFIX
ipv6 address suffix
Overview Use this command to configure the suffix to use when generating an address from
prefix information. Any addresses that were created with the EUI-64 suffix will be
removed, and new addresses will be added after the next Router Advertisement.
Use the no variant of this command to set it back to the default of disabled or set
to :: for the same result as the no variant.
Syntax
ipv6 address suffix <ipv6-addr-suffix>
no ipv6 address suffix
Default Disabled
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Example To configure the suffix to use when generating an address from prefix information
on vlan2, use the command:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 address suffix ::a2d8:0fd8
Related
commands
ipv6 nd accept-ra-pinfo
show running-config interface
Command
changes
Version 5.4.8-2.1: command added
Parameter Description
<ipv6-addr-suffix> In the format of ::X:X:X:X, for example ::a2d8:0fd8
To Next Page
Loading...
Need help?
General
