C613-50631-01 Rev A Command Reference for IE340 Series 2722
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
G.8032 ETHERNET RING PROTECTION SWITCHING COMMANDS
RAPS
-CHANNEL
raps-channel
Overview Use this command to specify which VLAN to use as a channel for G.8032
Ring-Automatic Protection Switching (R-APS) messages sent and received by this
G.8032 Ethernet Ring Protection (ERP) instance.
Use the no variant of this command to remove the VLAN from being used as the
R-APS channel VLAN.
Syntax
raps-channel <vid>
no raps-channel
Mode G8032 Configure Switch
Usage notes For a G.8032 ERP instance, a VLAN is used as a channel for carrying an R-APS
message. This VLAN is also used to identify the proper ring instance to all the other
nodes in the ring.
The VLAN must be tagged members of the G.8032 physical ring instance
associated with this ERP instance. A G.8032 physical ring instance must be
associated with this ERP instance. The ERP instance can not be enabled until this
raps-channel VLAN has been configured properly.
The ERP instance must be disabled when using the no variant.
Example To configure a VLAN with a VLAN-id of “103” as a R-APS channel for an ERP instance
named “blue”, use the following commands:
awplus(config)# g8032 erp-instance blue
awplus(g8032-config-switch)# raps-channel 103
Related
commands
g8032 erp-instance
Command
changes
Version 5.4.7-0.1: command added
Version 5.4.7-1.1: added to x310 series products
Version 5.4.7-2.1: added to x550 series products
Version 5.4.8-0.2: added to SBx8100 series products
Version 5.4.8-1.1: added to SBx908 GEN2 series products
Parameter Description
<vid> A single VLAN-id in the range 2 to 4094.
To Next Page
Loading...
Need help?
General
