C613-50631-01 Rev A Command Reference for IE340 Series 2060
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV6 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
IPV
6 TRAFFIC-FILTER
ipv6 traffic-filter
Overview This command adds an IPv6 hardware-based access-list to an interface. The
number of access-lists that can be added is determined by the amount of available
space in the hardware-based packet classification tables.
Use the no variant of this command to remove an IPv6 hardware-based access-list
from an interface.
Syntax
ipv6 traffic-filter <ipv6-access-list-name>
no ipv6 traffic-filter <ipv6-access-list-name>
Mode Interface Configuration (to apply an IPv6 hardware ACL to a specific switch port).
Usage notes This command adds an IPv6 hardware-based access-list to an interface. The
number of access-lists that can be added is determined by the amount of available
space in the hardware-based packet classification tables.
Examples To add access-list “acl1” as a traffic-filter to interface port1.0.1, enter the
commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# ipv6 traffic-filter acl1
To remove access-list “acl1” as a traffic-filter from interface port1.0.1, enter the
commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no ipv6 traffic-filter acl1
Related
commands
ipv6 access-list (named IPv6 hardware ACL)
(named IPv6 hardware ACL: ICMP entry)
(named IPv6 hardware ACL: IPv6 packet entry)
(named IPv6 hardware ACL: IP protocol entry)
(named IPv6 hardware ACL: TCP or UDP entry)
show ipv6 access-list (IPv6 Hardware ACLs)
Parameter Description
<ipv6-access-list-name> Hardware IPv6 access-list name.
To Next Page
Loading...
Need help?
General
