C613-50631-01 Rev A Command Reference for IE340 Series 1874
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
IPV
6 PIM RP-ADDRESS
ipv6 pim rp-address
Overview Use this command to statically configure RP (Rendezvous Point) address for IPv6
multicast groups.
Use the no variant of this command to remove a statically configured RP
(Rendezvous Point) address for IPv6 multicast groups.
Syntax
ipv6 pimv6 rp-address <IPv6-address> [<IPv6-access-list>]
[override]
no ipv6 pim rp-address <IPv6-address> [<IPv6-access-list>]
[override]
Mode Global Configuration
Usage notes The AlliedWare Plus™ PIM-SMv6 implementation supports multiple static RPs. It
also supports usage of static-RP and BSR mechanism simultaneously. The ipv6 pim
rp-address command is used to statically configure the RP address for IPv6
multicast groups.
You need to understand the following information before using this command.
If the RP-address that is configured by the BSR, and the RP-address that is
configured statically, are both available for a group range, then the RP-address
configured through BSR is chosen over the statically configured RP-address.
A single static-RP can be configured for multiple group ranges using software IPv6
access- lists (ACLs). However, configuring multiple static RPs (using ipv6 pim
rp-address command) with the same RP address is not allowed. The static-RP can
either be configured for the whole multicast group range ff00::/8 (without
using IPv6 ACLs) or for specific group ranges (when using IPv6 ACLs).
For example, configuring ipv6 pim rp-address 3ffe:10:10:5::153 will configure
static-RP 3ffe:10:10:5::153 for the default group range ff00::/8.
Configuring ipv6 pim rp-address 3ffee:20:20:5::153 grp-list will configure
static-RP 3ffe:20:20:5::153 for all the group ranges represented by permit
filters in the defined named grp-list ACL.
If multiple static-RPs are available for a group range, then one with the highest IPv6
address is chosen.
Parameter Description
<IPv6-address> Specify the IPv6 address of the Rendezvous Point, entered
in the form X:X::X:X.
<IPv6-access-list> Specify a Standard or an Extended software IPv6 access-list
name.
See IPv6 Software Access Control List (ACL) Commands for
supported IPv6 ACLs.
override Specify this optional parameter keyword to enable any
statically defined RPs to override dynamically learned RPs.
To Next Page
Loading...
Need help?
General
