C613-50631-01 Rev A Command Reference for IE340 Series 2335
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
SHOW
AUTH SUPPLICANT INTERFACE
show auth supplicant interface
Overview This command shows the supplicant (client device) state for the authentication
mode set for the interface. Use the optional brief parameter to show a summary of
the supplicant state.
Syntax
show auth-web supplicant interface <interface-list> [brief]
Mode Privileged Exec
Examples To display the authenticated supplicant on the interface port1.0.2, enter the
command:
awplus# show auth supplicant interface port1.0.2
To display brief summary output for the authenticated supplicant on the interface
port1.0.2, enter the command:
awplus# show auth supplicant interface port1.0.2 brief
Parameter Description
<interface-list> The interfaces or ports to configure. An interface-list can be:
•an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2,
or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
brief Brief summary of the supplicant state.
To Next Page
Loading...
Need help?
General
