C613-50631-01 Rev A Command Reference for IE340 Series 3429
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SFLOW COMMANDS
DEBUG
SFLOW
debug sflow
Overview This command enables sFlow® debug message logging, for sFlow sampling and
polling activity on the specified ports. If no ports are specified, sampling and/or
polling debug messages are enabled for all ports.
The no variant of this command disables sFlow sampling and or polling debug
message logging on the ports selected. If no ports are specified, sampling and/or
polling debug messages are disabled on all ports.
Syntax
debug sflow [interface <port-list>] [sampling][polling]
no debug sflow [interface <port-list>] [sampling][polling]
Default The sFlow sampling and or polling debug is disabled.
Mode Privileged Exec
Examples To enable sFlow debug message logging for polling and sampling on port1.0.1
and port1.0.7, use the commands:
awplus# debug sflow interface port1.0.1,port1.0.7 sampling
polling
To enable logging and polling of sFlow debug messages for polling and sampling
on all ports, use the command:
awplus# debug sflow sampling polling
Related
commands
show debugging sflow
no debug all
Parameter Description
interface Interface information.
<port-list> The ports for which sFlow debug is to be enabled. The ports to
display information about. The port list can be:
• a switch port (e.g. port1.0.12)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.24
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.1-1.0.24.
sampling Debug sFlow sampling for the specified port(s).
polling Debug sFlow polling for the specified port(s).
To Next Page
Loading...
Need help?
General
