C613-50631-01 Rev A Command Reference for IE340 Series 2403
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LIGHTWEIGHT DIRECTORY ACCESS PROTOCOL (LDAP) COMMANDS
DEADTIME
(LDAP-SERVER)
deadtime (ldap-server)
Overview Use this command to configure the deadtime for an LDAP server. The configured
deadtime is how long in seconds before an unresponsive LDAP server is
considered dead.
Use the no variant of this command to remove the deadtime configured on an
LDAP server. When you remove the deadtime, the server will never be considered
dead.
Syntax
deadtime <0-1440>
no deadtime
Default 0 seconds (the LDAP server is never considered dead)
Mode LDAP Server Configuration
Example To set the deadtime to 20 seconds for the LDAP server called ‘Server1’, use the
commands:
awplus# configure terminal
awplus(config)# ldap-server Server1
awplus(config-ldap-server)# deadtime 20
To reset the deadtime to the default for ‘Server1’, use the commands:
awplus# configure terminal
awplus(config)# ldap-server Server1
awplus(config-ldap-server)# no deadtime
Related
commands
host (ldap-server)
ldap-server
port (ldap-server)
retransmit (ldap-server)
show ldap server group
timeout (ldap-server)
Command
changes
Version 5.5.2-1.1: command added
Parameter Description
<0-1440> The number of seconds that the server can be unresponsive for
before it is considered dead.
To Next Page
Loading...
Need help?
General
