Allied Telesis IE340 Series - show trigger

C613-50631-01 Rev A Command Reference for IE340 Series 3375
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
TRIGGER COMMANDS
SHOW
TRIGGER
show trigger
Overview This command displays configuration and diagnostic information about the
triggers configured on the device. Specify the show trigger command without
any options to display a summary of the configuration of all triggers.
Syntax
show trigger [<1-250>|counter|full]
Mode Privileged Exec
Example To get summary information about all triggers, use the following command:
awplus# show trigger
Parameter Description
<1-250> Displays detailed information about a specific trigger, identified by its
trigger ID.
counter Displays statistical information about all triggers.
full Displays detailed information about all triggers.
Table 67-1: Example output from show trigger
awplus#show trigger 
TR# Type & Details Name Ac Te Repeat #Scr Days/Date
----------------------------------------------------------------------------- 
001 CPU (80% any) Busy CPU Y N 5 1 smtwtfs 
005 Periodic (30 min) Regular status check Y N Continuous 1 -mtwtf- 
007 Memory (85% up) High mem usage Y N 8 1 smtwtfs 
011 Time (00:01) Weekend access Y N Continuous 1 ------s 
013 Reboot Y N Continuous 2 smtwtfs 
019 Ping-poll (5 up) Connection to svr1 Y N Continuous 1 smtwtfs
-----------------------------------------------------------------------------
Table 67-2: Parameters in the output of show trigger
Parameter Description
TR# Trigger identifier (ID).
Type &
Details
The trigger type, followed by the trigger details in brackets.
Name Descriptive name of the trigger configured with the description
(trigger) command.
Ac Whether the trigger is active (Y), or inactive (N).
Te Whether the trigger is in test mode (Y) or not (N).