Allied Telesis IE340 Series - show port-security intrusion

C613-50631-01 Rev A Command Reference for IE340 Series 615
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SWITCHING COMMANDS
SHOW
PORT-SECURITY INTRUSION
show port-security intrusion
Overview Use this command to show the intrusion list. If the port is not specified, the entire
intrusion table is shown.
Syntax
show port-security intrusion [interface <port>]
Mode Privileged Exec
Example To see the intrusion list on port1.0.2, use the following command:
awplus# show port-security intrusion interface port1.0.2
Output Figure 15-11: Example output from the show port-security intrusion command
for port1.0.2
Related
commands
clear port-security intrusion
show port-security interface
switchport port-security
switchport port-security aging
switchport port-security maximum
switchport port-security violation
Parameter Description
interface Specify a port
<port> Specify the switch port to display information about, e.g.
port1.0.4.
Port Security Intrusion List 
Interface: port1.0.2 -3 intrusion(s) detected 
11-22-33-44-55-04 11-22-33-44-55-06 11-22-33-44-55-08