C613-50631-01 Rev A Command Reference for IE340 Series 2602
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DHCP SNOOPING COMMANDS
SHOW
IP SOURCE BINDING
show ip source binding
Overview Use this command to display static entries in the DHCP snooping database. These
are the entries that have been added by using the ip source binding command.
Syntax
show ip source binding
Mode User Exec and Privileged Exec
Example To display static entries in the DHCP snooping database information, use the
command:
awplus# show ip source binding
Related
commands
ip source binding
show ip dhcp snooping binding
Table 62: Example output from the show ip source binding command
awplus# show ip source bindingď€
ď€
IP Source Bindings:ď€
ď€
Client MAC Expiresď€
IP Address Address VLAN Port (sec) Typeď€
----------------------------------------------------------------ď€
1.1.1.1 0000.1111.2222 1 port1.0.1 Infinite Staticď€
Table 63: Parameters in the output from the show ip source binding command
Parameter Description
Client IP
Address
The IP address of the DHCP client.
MAC Address The MAC address of the DHCP client.
VLAN The VLAN ID the packet is received on.
Port The Layer 2 port name the packet is received on.
Expires (sec) Always infinite for static bindings, or when the leave time in
the DHCP message was 0xffffffff (infinite).
Type DHCP Snooping binding type: Static
To Next Page
Loading...
Need help?
General
