C613-50631-01 Rev A Command Reference for IE340 Series 1431
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
DESCRIPTION
neighbor description
Overview Use this command to associate a description with a BGP or a BGP4+ neighbor. We
recommend adding descriptions to defined neighbors, so any network
administrators or network engineers can see a description of connected BGP or
BGP4+ peers on the device.
Use the no variant of this command to remove the description from a BGP or a
BGP4+ neighbor.
Syntax
neighbor <neighborid> description <description>
no neighbor <neighborid> description [<description>]
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] Router Configuration
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+
neighbor, entered in hexadecimal in the
format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) command, and neighbor route-map
command. When this parameter is used with
this command, the command applies on all
peers in the specified group.
<description> Enter up to 80 characters of text describing the neighbor.
To Next Page
Loading...
Need help?
General
