C613-50631-01 Rev A Command Reference for IE340 Series 1430
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
DEFAULT-ORIGINATE
Examples
[BGP4+]
To allow a device to originate default route to neighbor 2001:0db8:010d::1, when
the device's route table contains at least one route matching the route map
’myroute’, use the commands:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# address-family ipv6
awplus(config-router-af)# neighbor 2001:0db8:010d::1
default-originate route-map myroute
To stop a device originating default route to neighbor 2001:0db8:010d::1, use the
commands:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# address-family ipv6
awplus(config-router-af)# no neighbor 2001:0db8:010d::1
default-originate route-map myroute
To allow a device to originate default route to peer group ‘group1’, when the
device's route table contains at least one route matching the route map ’myroute’,
use the commands:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# neighbor group1 peer-group
awplus(config-router)# neighbor 2001:0db8:010d::1 remote-as 10
awplus(config-router)# address-family ipv6
awplus(config-router-af)# neighbor 2001:0db8:010d::1
peer-group group1
awplus(config-router-af)# neighbor group1 default-originate
route-map myroute
To stop a device originating default route to peer group ‘group1’, use the
commands:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# address-family ipv6
awplus(config-router-af)# no neighbor group1 default-originate
route-map myroute
Related
commands
neighbor peer-group (add a neighbor)
neighbor route-map
Command
changes
Added to AlliedWare Plus prior to 5.4.6-1
Version 5.4.7-2.1: BGP support added for x510 and x550 series
Version 5.4.7-2.4: BGP support added for IE300 series
To Next Page
Loading...
Need help?
General
