Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2937
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF AREA
show atmf area
Overview Use this command to display information about an AMF area. On AMF controllers,
this command displays all areas that the controller is aware of. On remote AMF
masters, this command displays the controller area and the remote local area. On
gateways, this command displays the controller area and remote master area.
Syntax
show atmf area [detail] [<area-name>]
Mode Privileged Exec
Example 1 To show information about all areas, use the command:
controller-1# show atmf area
The following figure shows example output from running this command on a
controller.
The following figure shows example output from running this command on a
remote master.
Parameter Description
detail Displays detailed information
<area-name> Displays information about master and gateway nodes in the
specified area only.
Table 62: Example output from the show atmf area command on a Controller.
controller-1#show atmf area 

ATMF Area Information: 

* = Local area 

Area Area Local Remote Remote Node
Name ID Gateway Gateway Master Count
----------------------------------------------------------------------------
* NZ 1 Reachable N/A N/A 3 
Wellington 2 Reachable Reachable Auth OK 120 
Canterbury 3 Reachable Reachable Auth Error - 
SiteA-AREA 14 Unreachable Unreachable Unreachable - 
Auckland 100 Reachable Reachable Auth Start - 
Southland 120 Reachable Reachable Auth OK 54

Area count: 6 Area node count: 177

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English