Allied Telesis IE340 Series - show ip traffic

C613-50631-01 Rev A Command Reference for IE340 Series 921
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IP ADDRESSING AND PROTOCOL COMMANDS
SHOW
IP TRAFFIC
show ip traffic
Overview Use this command to display statistics regarding IP traffic sent and received by all
interfaces on the device, showing totals for IP and IPv6 and then broken down into
sub-categories such as TCP, UDP, ICMP and their IPv6 equivalents when
appropriate.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip traffic
Mode Privileged Exec
Example To display IP traffic statistics, use the command:
awplus# show ip traffic
Output Figure 22-14: Example output from the show ip traffic command
awplus#show ip traffic 
IP: 
168475 packets received 
168475 delivered 
208099 sent 
35 dropped due to missing route 
22646409 bytes received 
126783216 bytes sent 
InCsumErrors 0 
InNoECTPkts 168475 
InECT1Pkts 0 
InECT0Pkts 0 
InCEPkts 0 
In107 Destination Unreachable 
Out11 Destination Unreachable 
IPv6: 
14 packets received 
14 received packets delivered 
18 packets transmitted 
...
ICMP6: 
4 messages sent 
...
UDP6: 
Udp6RcvbufErrors 0 
...
UDPLite6: 
UdpLite6RcvbufErrors 0 
...