C613-50631-01 Rev A Command Reference for IE340 Series 3202
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
SNMP
-SERVER HOST
snmp-server host
Overview This command specifies an SNMP trap host destination to which Trap or Inform
messages generated by the device are sent.
For SNMP version 1 and 2c you must specify the community name parameter. For
SNMP version 3, specify the authentication/encryption parameters and the user
name. If the version is not specified, the default is SNMP version 1. Inform
messages can be sent instead of traps for SNMP version 2c and 3.
Use the no variant of this command to remove an SNMP trap host. The trap host
must already exist.
The trap host is uniquely identified by:
• host IP address (IPv4 or IPv6),
• inform or trap messages,
• community name (SNMPv1 or SNMP v2c) or the authentication/encryption
parameters and user name (SNMP v3).
Syntax
snmp-server host {<ipv4-address>|<ipv6-address>} [traps]
[version 1] <community-name>]
snmp-server host {<ipv4-address>|<ipv6-address>}
[informs|traps] version 2c <community-name>
snmp-server host {<ipv4-address>|<ipv6-address>}
[informs|traps] version 3 {auth|noauth|priv} <user-name>
no snmp-server host {<ipv4-address>|<ipv6-address>} [traps]
[version 1] <community-name>
no snmp-server host {<ipv4-address>|<ipv6-address>}
[informs|traps] version 2c <community-name>
no snmp-server host {<ipv4-address>|<ipv6-address>}
[informs|traps] version 3 {auth|noauth|priv} <user-name>
Parameter Description
<ipv4-address> IPv4 trap host address in the format A.B.C.D, for example,
192.0.2.2.
<ipv6-address> IPv6 trap host address in the format x:x::x:x for example,
2001:db8::8a2e:7334.
informs Send Inform messages to this host.
traps Send Trap messages to this host (default).
version SNMP version to use for notification messages. Default:
version 1.
1 Use SNMPv1(default).
2c Use SNMPv2c.
3 Use SNMPv3.
To Next Page
Loading...
Need help?
General
