Allied Telesis IE340 Series - auth-mac authentication

C613-50631-01 Rev A Command Reference for IE340 Series 2265
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
AUTH
-MAC AUTHENTICATION
auth-mac authentication
Overview This command overrides the default MAC authentication method on an interface
by allowing you to apply a user-defined named list.
Use the no variant of this command to remove the named list from the interface
and apply the default method.
Syntax
auth-mac authentication {default|<list-name>}
no auth-mac authentication
Default The default method list is applied to an interface by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Example To apply the named list 'vlan10_auth' on the vlan10 interface, use the commands:
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# auth-mac authentication vlan10_auth
To remove the named list from the vlan10 interface and set the authentication
method back to default, use the commands:
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# no auth-mac authentication
Related
commands
aaa authentication auth-mac
Command
changes
Version 5.4.8-2.1: Command added to AR2050V, AR3050S, AR4050S
Parameter Description
default Apply the default authentication method list
<list-name> Apply a user-defined named list