C613-50631-01 Rev A Command Reference for IE340 Series 3107
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
USE
-SUBSCRIBER-ID
use-subscriber-id
Overview Use this command to configure a DHCP server to use a subscriber identifier
substitution for a client identifier on all DHCP packets for a given remote address
pool.
Use the no variant of this command to remove the subscriber identifier
substitution for a client identifier.
Syntax
use-subscriber-id
no use-subscriber-id
Default Disabled
Mode DHCP Configuration
Usage notes If the subscriber identifier for the client identifier substitution is enabled for a
remote pool, then all relayed packets destined for the poll must contain the relay
agent information option. This includes the subscriber identifier sub-option.
If not, then the relayed packet will be silently ignored as the situation is considered
as an invalid operation.
Example To set the subscriber-id and client-id substitution for the DHCP pool ‘Campus-1’,
use the commands:
awplus# configure terminal
awplus(config)# ip dhcp pool Campus-1
awplus(dhcp-config)# use-subscriber-id
To Next Page
Loading...
