C613-50631-01 Rev A Command Reference for IE340 Series 3207
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
SNMP
-SERVER STARTUP-TRAP-DELAY
snmp-server startup-trap-delay
Overview Use this command to set the time in seconds after following completion of the
device startup sequence before the device sends any SNMP traps (or SNMP
notifications).
Use the no variant of this command to restore the default startup delay of 30
seconds.
Syntax
snmp-server startup-trap-delay <delay-time>
no snmp-server startup-trap-delay
Default The SNMP server trap delay time is 30 seconds. The no variant restores the default.
Mode Global Configuration
Example To delay the device sending SNMP traps until 60 seconds after device startup, use
the following commands:
awplus# configure terminal
awplus(config)# snmp-server startup-trap-delay 60
To restore the sending of SNMP traps to the default of 30 seconds after device
startup, use the following commands:
awplus# configure terminal
awplus(config)# no snmp-server startup-trap-delay
Validation
Commands
show snmp-server
Parameter Description
<delay-time> Specify an SNMP trap delay time in seconds in the range of 30
to 600 seconds.
To Next Page
Loading...
Need help?
General
