C613-50631-01 Rev A Command Reference for IE340 Series 3197
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
SNMP
-SERVER ENGINEID LOCAL
snmp-server engineID local
Overview Use this command to configure the SNMPv3 engine ID. The SNMPv3 engine ID is
used to uniquely identify the SNMPv3 agent on a device when communicating
with SNMP management clients. Once an SNMPv3 engine ID is assigned, this
engine ID is permanently associated with the device until you change it.
Use the no variant of this command to set the user defined SNMPv3 engine ID to a
system generated pseudo-random value by resetting the SNMPv3 engine. The no
snmp-server engineID local command has the same effect as the snmp-server
engineID local default command.
Note that the snmp-server engineID local reset command is used to force the
system to generate a new engine ID when the current engine ID is also system
generated.
Syntax
snmp-server engineID local {<engine-id>|default}
no snmp-server engineID local
Mode Global Configuration
Usage notes All devices must have a unique engine ID which is permanently set unless it is
configured by the user.
Example To set the SNMPv3 engine ID to 800000cf030000cd123456, use the following
commands:
awplus# configure terminal
awplus(config)# snmp-server engineID local
800000cf030000cd123456
To set a user defined SNMPv3 engine ID back to a system generated value, use the
following commands:
awplus# configure terminal
awplus(config)# no snmp-server engineID local
Output The following example shows the engine ID values after configuration:
Parameter Description
<engine-id> Specify SNMPv3 Engine ID value, a string of up to 27 characters.
default Set SNMPv3 engine ID to a system generated value by resetting the
SNMPv3 engine, provided the current engine ID is user defined. If the
current engine ID is system generated, use the snmp-server engineID
local reset command to force the system to generate a new engine
ID.
To Next Page
Loading...
Need help?
General
