C613-50631-01 Rev A Command Reference for IE340 Series 1016
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ROUTING COMMANDS
SHOW
IPV6 ROUTE
show ipv6 route
Overview Use this command to display the IPv6 routing table for a protocol or from a
particular table.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 route
[bgp|connected|database|ospf|rip|static|summary|<ipv6-address>
|<ipv6-prefix/prefix-length>]
Mode User Exec and Privileged Exec
Example To display all IPv6 routes with all parameters turned on, use the following
command:
awplus# show ipv6 route
To display all database entries for all IPv6 routes, use the following command:
awplus# show ipv6 route database
Parameter Description
bgp Displays only the routes learned from BGP.
connected Displays only the routes learned from connected
interfaces.
database Displays only the IPv6 routing information extracted
from the database.
ospf Displays only the routes learned from OSPFv3.
rip Displays only the routes learned from RIPng.
static Displays only the IPv6 static routes you have
configured.
summary Displays summary information from the IPv6 routing
table.
<ipv6-address> Displays the routes for the specified address in the
IPv6 routing table.
<ipv6-prefix>/<prefix-
length>
Displays only the routes for the specified IPv6 prefix.
To Next Page
Loading...
Need help?
General
