C613-50631-01 Rev A Command Reference for IE340 Series 1927
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-DM COMMANDS
IP
PIM STATE-REFRESH ORIGINATION-INTERVAL
ip pim state-refresh origination-interval
Overview This command configures a PIM state-refresh origination-interval value. The
origination interval is the number of seconds between PIM state refresh control
messages. The default is 60 seconds.
Use the no variant of this command to return the origination interval to the
default.
Syntax
ip pim state-refresh origination-interval <interval>
no ip pim state-refresh origination-interval
Default The state-refresh origination-interval is set to 60 seconds by default, and is reset
using negation.
Mode Interface Configuration for a VLAN interface.
Example
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip pim state-refresh origination-interval 65
Parameter Description
<interval> <1-100> The integer value in seconds (no fractional seconds
accepted). The default state-refresh origination-interval value is
60.
To Next Page
Loading...
Need help?
General
