Allied Telesis IE340 Series User Manual

63
C613-50631-01 Rev A Command Reference for IE340 Series 3213
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LLDP Commands
Introduction
Overview LLDP and LLDP-MED can be configured using the commands in this chapter, or by
using SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (see the Support for
Allied Telesis Enterprise MIBs in AlliedWare Plus).
The Voice VLAN feature can be configured using commands in VLAN Commands
chapter.
For more information about LLDP, see the LLDP Feature Overview and
Configuration Guide.
LLDP can transmit a lot of data about the network. Typically, the network
information gathered using LLDP is transferred to a Network Management System
by SNMP. For security reasons, we recommend using SNMPv3 for this purpose (see
the SNMP Feature Overview and Configuration Guide).
LLDP operates over physical ports only. For example, it can be configured on switch
ports that belong to static or dynamic channel groups, but not on the channel
groups themselves.
Command List •“clear lldp statistics” on page 3215
•“clear lldp table” on page 3216
•“debug lldp” on page 3217
•“lldp faststart-count” on page 3219
•“lldp holdtime-multiplier” on page 3220
•“lldp management-address” on page 3221
•“lldp med-notifications” on page 3222
•“lldp med-tlv-select” on page 3223
•“lldp non-strict-med-tlv-order-check” on page 3226
•“lldp notification-interval” on page 3227
•“lldp notifications” on page 3228

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English