Allied Telesis IE340 Series - server mutual-authentication

C613-50631-01 Rev A Command Reference for IE340 Series 2386
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AAA COMMANDS
SERVER
MUTUAL-AUTHENTICATION
server mutual-authentication
Overview This command enables or disables mutual certificate authentication for all
RadSecProxy servers. When enabled, the RadSecProxy AAA application will send a
local X.509 certificate to the server when establishing a TLS connection.
Use the no variant of this command to disable mutual certificate validation
causing the RadSecProxy AAA application to not transmit a certificate to the server.
NOTE: If mutual authentication is disabled on the client (AAA) application but enabled
on the server, a connection will not be established.
Syntax
server mutual-authentication
no server mutual-authentication
Default Mutual authentication is enabled by default.
Mode RadSecProxy AAA Configuration Mode
Example Disable mutual certificate validation with the following command:
awplus# configure terminal
awplus(config)# radius-secure-proxy aaa
awplus(config-radsecproxy-aaa)# no server
mutual-authentication
Related
commands
radius-secure-proxy aaa
server name-check
server (radsecproxy-aaa)
Command
changes
Version 5.4.6-2.1: command added