C613-50631-01 Rev A Command Reference for IE340 Series 3381
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
TRIGGER COMMANDS
TIME
(TRIGGER)
time (trigger)
Overview This command specifies the time of day when the trigger is permitted to activate.
The after parameter specifies the start of a time period that extends to midnight
during which trigger may activate. By default the value of this parameter is
00:00:00 (am); that is, the trigger may activate at any time. The before parameter
specifies the end of a time period beginning at midnight during which the trigger
may activate. By default the value of this parameter is 23:59:59; that is, the trigger
may activate at any time. If the value specified for before is later than the value
specified for after, a time period from “ after ” to “ before ” is defined, during which
the trigger may activate. This command is not applicable to time triggers ( type
time).
The following figure illustrates how the before and after parameters operate.
Syntax
time {[after <hh:mm:ss>] [before <hh:mm:ss>]}
Mode Trigger Configuration
00:00 06:00 12:00 18:00 00:00
00:00 06:00 12:00 18:00 00:00
00:00 06:00 12:00 18:00 00:00
00:00 06:00 12:00 18:00 00:00
BEFORE=08:00
AFTER=18:00
AFTER=18:00 BEFORE=08:00
AFTER=08:00 BEFORE=18:00
Period when trigger may activate.Key:
Period when trigger may not activate.
TRG_02
Parameter Description
after<hh:mm:ss> The earliest time of day when the trigger may be activated.
before<hh:mm:ss> The latest time of day when the trigger may be activated.
To Next Page
Loading...
Need help?
General
