Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 1887
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
SHOW
DEBUGGING IPV6 PIM SPARSE-MODE
show debugging ipv6 pim sparse-mode
Overview Use this command to see what debugging is turned on for PIM-SMv6.
For information on filtering and saving command output, see the “Getting_Started
with AlliedWare Plus” Feature Overview and Configuration_Guide.
Syntax
show debugging ipv6 pim sparse-mode
Mode User Exec and Privileged Exec
Example To display PIM-SMv6 debugging settings, use the command:
awplus# show debugging ipv6 pim sparse-mode
Figure 36-3: Example output from the show debugging ipv6 pim
sparse-mode command
Related
commands
debug ipv6 pim sparse-mode
undebug ipv6 pim sparse-mode
awplus#show debugging ipv6 pim sparse-mode
Debugging status:
PIM event debugging is on
PIM MFC debugging is on
PIM state debugging is on
PIM packet debugging is on
PIM Hello HT timer debugging is on
PIM Hello NLT timer debugging is on
PIM Hello THT timer debugging is on
PIM Join/Prune JT timer debugging is on
PIM Join/Prune ET timer debugging is on
PIM Join/Prune PPT timer debugging is on
PIM Join/Prune KAT timer debugging is on
PIM Join/Prune OT timer debugging is on
PIM Assert AT timer debugging is on
PIM Register RST timer debugging is on
PIM Bootstrap BST timer debugging is on
PIM Bootstrap CRP timer debugging is on

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English