C613-50631-01 Rev A Command Reference for IE340 Series 2723
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
G.8032 ETHERNET RING PROTECTION SWITCHING COMMANDS
SERVICE
ONM
service onm
Overview Use this command to enable the ONM service, which underlies CFM and G.8032.
Use the no version of the command to disable the unused ONM service.
Syntax
service onm
no service onm
Default Enabled
Mode Global Configuration
Usage notes Disabling the service can reduce memory usage on the switch, particularly when
many VLANs are configured on ports.
Disabling the service will only take effect after you save the configuration and
restart the device.
Example To disable the ONM service, use the commands:
awplus# configure terminal
awplus(config)# no service onm
Output Figure 55-1: Example output from no service onm
Command
changes
Version 5.5.0-2.1: command added
awplus(config)#no service onmď€
% Save the config and restart the device for this change to take
effect
To Next Page
Loading...
Need help?
General
