C613-50631-01 Rev A Command Reference for IE340 Series 2898
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
CREATE
(AMF-PROVISION)
create (amf-provision)
Overview This command sets up an empty directory on the backup media for use with a
provisioned node. This directory can have configuration and release files copied to
it from existing devices. Alternatively, the configuration files can be created by the
user.
An alternative way to create a new provisioned node is with the command clone
(amf-provision).
This command can only run on AMF master nodes.
Syntax
create
Mode AMF Provisioning
Usage notes This command is only available on master nodes in the AMF network.
A date and time is assigned to the new provisioning directory reflecting when this
command was executed. If there is a backup or provisioned node with the same
name on another AMF master then the most recent one will be used.
Example To create a new provisioned node named “device2” use the command:
device1# atmf provision node device2
device1(atmf-provision)# create
Running this command will create the following directories:
•<media>:atmf/<atmf_name>/nodes/<node>
•<media>:atmf/<atmf_name>/nodes/<node>/flash
To confirm the new node’s settings, use the command:
device1# show atmf backup
The output for the show atmf backup command is shown in the following figure,
and shows details for the new provisioned node ‘device2’.
To Next Page
Loading...
Need help?
General
