Allied Telesis IE340 Series - show mrp ring

C613-50631-01 Rev A Command Reference for IE340 Series 2763
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MEDIA REDUNDANCY PROTOCOL (MRP) COMMANDS
SHOW
MRP RING
show mrp ring
Overview Use this command to show the MRP ring settings for a specific ring, or for all rings.
Syntax
show mrp ring [<ring-id>]
Mode Privileged Exec
Example To show the settings for all MRP rings, use the command:
awplus# show mrp ring
To show the settings for MRP ring 1, use the command:
awplus# show mrp ring 1
Output Figure 56-6: Example output from show mrp ring
Parameter Description
<ring-id> The ID of an MRP ring.
awplus#show mrp ring
Media Redundancy Protocol - Ring Information
MRP Ring 1
Domain ID: ffffffff-ffff-ffff-ffff-ffffffffffff
Domain Name:
Ring Status: Enabled
Operating Mode: CLI
Role: Manager
Network Status: Open
Port1: port1.0.25
Status: Forwarding
Port2: port1.0.29
Status: Forwarding
Vlan ID:
React on Link Change: No
Profile: 200ms
Topology Change Interval: 10ms
Topology Change Count: 3
Short Test Frame Interval: 10ms
Default Test Frame Interval: 20ms
Test Monitoring Interval Count: 3
Test Monitoring Ext Interval Count: 0
Non-blocking MRC Supported: No