Allied Telesis IE340 Series - show port-security interface

C613-50631-01 Rev A Command Reference for IE340 Series 614
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SWITCHING COMMANDS
SHOW
PORT-SECURITY INTERFACE
show port-security interface
Overview Use this command to show the current port-security configuration and status.
Syntax
show port-security interface <port>
Mode Privileged Exec
Example To see the port-security status on port1.0.2, use the following command:
awplus# show port-security interface port1.0.2
Output Figure 15-10: Example output from the show port-security interface command
Related
commands
clear port-security intrusion
show port-security intrusion
switchport port-security
switchport port-security aging
switchport port-security maximum
switchport port-security violation
Parameter Description
<port> Specify the switch port to display information about, e.g.
port1.0.4.
Port Security configuration
Security Enabled : YES
Port Status : ENABLED
Violation Mode : TRAP
Aging : OFF
Maximum MAC Addresses : 3
Total MAC ddresses : 1
Lock Status : UNLOCKED
Security Violation Count : 0
Last Violation Source Address : None