C613-50631-01 Rev A Command Reference for IE340 Series 2944
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF AREA NODES
show atmf area nodes
Overview Use this command to display summarized information about an AMF controller’s
remote nodes.
Note that this command can only be run from a controller node.
Syntax
show atmf area nodes <area-name> [<node-name>]
Mode Privileged Exec
Usage notes If you do not limit the output to a single area or node, this command lists all remote
nodes that the controller is aware of. This can be a very large number of nodes.
Example To show summarized information for all the nodes in area ‘Wellington’, use the
command:
controller-1# show atmf area nodes Wellington
The following figure shows partial example output from running this command.
Parameter Description
<area-name> Displays information about nodes in the specified area.
<node-name> Displays information about the specified node.
Table 68: Output from the show atmf area nodes Wellington command
controller-1#show atmf area nodes Wellington
Wellington Area Node Information:
Node Device ATMF Parent Node
Name Type Master SC Domain Depth
--------------------------------------------------------------------------------
well-gate x230-18GP N N well-master 1
well-master AT-x930-28GPX Y N none 0
Wellington node count 2
Table 69: Parameter definitions from the show atmf area nodes command
Parameter Definition
Node Name The name assigned to a particular node.
Device Type The Product series name.
ATMF Master Whether the node is an AMF master node for its area (‘Y‘ if it is
and ‘N’ if it is not).
To Next Page
Loading...
Need help?
General
