C613-50631-01 Rev A Command Reference for IE340 Series 2802
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
BACKUP AREA-MASTERS ENABLE
atmf backup area-masters enable
Overview Use this command to enable backup of remote area-masters from the AMF
controller. This command is only valid on AMF controllers.
Use the no form of the command to stop backups of remote area-masters.
Syntax
atmf backup area-masters enable
no atmf backup area-masters enable
Mode Global configuration
Default Remote area backups are disabled by default
Usage notes Use the following commands to configure the remote area-master backups:
• atmf backup to configure when the backups begin and how often they run
• atmf backup server to configure the backup server.
We recommend using the ext3 or ext4 filesystem on external media that are used
for AMF backups.
Example To enable scheduled backups of AMF remote area-masters, use the commands:
controller-1# configure terminal
controller-1(config)# atmf backup area-masters enable
To disable scheduled backups of AMF remote area-masters, use the commands:
controller-1# configure terminal
controller-1(config)# no atmf backup area-masters enable
Related
commands
atmf backup server
atmf backup
show atmf backup area
To Next Page
Loading...
Need help?
General
