C613-50631-01 Rev A Command Reference for IE340 Series 2842
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
PROVISION (INTERFACE)
atmf provision (interface)
Overview This command configures a specified port on an AMF node to accept a provisioned
node, via an AMF link, some time in the future.
Use the no variant of this command to remove the provisioning on the node.
Syntax
atmf provision <nodename>
no atmf provision
Mode Interface Configuration for a switchport, a static aggregator, dynamic channel
group or an Eth port on an AR-Series device.
Usage notes The port should be configured as an AMF link or cross link and should be ‘down’ to
add or remove a provisioned node.
Example To provision an AMF node named node1 for port1.0.1, use the commands:
host1(config)# interface port1.0.1
host1(config-if)# atmf provision node1
Related
commands
atmf provision node
clone (amf-provision)
configure boot config (amf-provision)
configure boot system (amf-provision)
copy (amf-provision)
create (amf-provision)
delete (amf-provision)
identity (amf-provision)
license-cert (amf-provision)
locate (amf-provision)
show atmf provision nodes
show atmf links
switchport atmf-link
switchport atmf-crosslink
Parameter Description
<nodename> The name of the provisioned node that will appear on
the AMF network in the future.
To Next Page
Loading...
Need help?
General
