C613-50631-01 Rev A Command Reference for IE340 Series 1263
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPFV3 FOR IPV6 COMMANDS
MAX
-CONCURRENT-DD (IPV6 OSPF)
max-concurrent-dd (IPv6 OSPF)
Overview Use this command to limit the number of neighbors that can be concurrently
processed in the database exchange. The specified value limits the number of
neighbors from all interfaces, not per interface.
Use the no variant of this command to have no limit on the maximum number of
LSAs.
Syntax
max-concurrent-dd <max-neighbors>
no max-concurrent-dd
Mode Router Configuration
Usage notes This command is useful where bringing up several adjacencies on a router is
affecting performance. In this situation, you can often enhance the system
performance by limiting the number of neighbors that can be processed
concurrently.
Example The following example sets the max-concurrent-dd value to allow only 4
neighbors to be processed at a time.
awplus# configure terminal
awplus(config)# router ipv6 ospf
awplus(config-router)# max-concurrent-dd 4
Related
commands
router ipv6 ospf
Parameter Description
<max-neighbors> <1-65535> The maximum number of neighbors.
To Next Page
Loading...
Need help?
General
