Allied Telesis IE340 Series - show application-proxy whitelist supplicant

C613-50631-01 Rev A Command Reference for IE340 Series 2931
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
APPLICATION-PROXY WHITELIST SUPPLICANT
show application-proxy whitelist supplicant
Overview Use this command to display the current configuration and status for each
supplicant attached to an application-proxy whitelist port.
Syntax
show application-proxy whitelist supplicant [interface
<interface-list>|<mac-addr>|brief]
Mode Privileged Exec
Example To display the supplicant information for all ports, use the command:
awplus# show application-proxy whitelist supplicant
To display the supplicant information for port1.0.4, use the command:
awplus# show application-proxy whitelist supplicant interface
port1.0.4
Parameter Description
interface
<interface-list>
The interfaces or ports to display information about. An
interface-list can be:
• a switchport (e.g. port1.0.4)
• a static channel group (e.g. sa2)
• a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen (e.g.
port1.0.1-1.0.4)
• a comma-separated list (e.g. port1.0.1,port1.0.3-1.0.4). Do
not mix port types in the same list.
The specified interface must exist.
<mac-addr> MAC (hardware) address of the supplicant.Entry format is
HHHH.HHHH.HHHH (hexadecimal)
brief Brief summary of the supplicant state.