C613-50631-01 Rev A Command Reference for IE340 Series 2326
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
SHOW
AUTH DIAGNOSTICS
show auth diagnostics
Overview This command shows authentication diagnostics, optionally for the specified
interface, which may be a static channel (or static aggregator) or a dynamic (or
LACP) channel group or a switch port.
If no interface is specified then authentication diagnostics are shown for all
interfaces.
Syntax
show auth diagnostics [interface <interface-list>]
Mode Privileged Exec
Example To display authentication diagnostics for port1.0.6, enter the command:
awplus# show auth diagnostics interface port1.0.6
Parameter Description
interface Specify ports to show.
<interface-list> The interfaces or ports to configure. An interface-list can be:
•an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2,
or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
To Next Page
Loading...
