C613-50631-01 Rev A Command Reference for IE340 Series 1791
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
DEBUG
PIM SPARSE-MODE
debug pim sparse-mode
Overview Use this command to turn on some or all PIM-SM debugging.
Use the no variant of this command to turn off some or all PIM-SM debugging.
Syntax
debug pim sparse-mode [all] [events] [mfc] [mib] [nexthop] [nsm]
[packet] [state] [mtrace]
no debug pim sparse-mode [all] [events] [mfc] [mib] [nexthop]
[nsm] [packet] [state] [mtrace]
Mode Privileged Exec and Global Configuration
Example
awplus# configure terminal
awplus(config)# debug pim sparse-mode all
Related
commands
show debugging pim sparse-mode
Command
changes
Version 5.4.7-1.1: VRF-lite support added SBx8100.
Version 5.4.8-1.1: VRF-lite support added x930, SBx908 GEN2.
Parameter Description
all Activates/deactivates all PIM-SM debugging.
events Activates debug printing of events.
mfc Activates debug printing of MFC (Multicast Forwarding Cache in
kernel) add/delete/updates.
mib Activates debug printing of PIM-SM MIBs.
nexthop Activates debug printing of PIM-SM next hop communications.
nsm Activates debugging of PIM-SM Network Services Module
communications.
packet Activates debug printing of incoming and/or outgoing packets.
state Activates debug printing of state transition on all PIM-SM FSMs.
mtrace Activates debug printing of multicast traceroute.
To Next Page
Loading...
Need help?
General
